Installation; Inspection And Uncrating - Process Technology Lufran LUF Series Manual

Installation:

Note: Carefully read this entire section before installation. The installation of this unit must be performed
by qualified technicians.
En raison du poids de l'appareil, NE PAS
ESSAYER de déplacer ou de soulever l'appareil
sans l'équipement de manutention de matériel
approprié.

Inspection and Uncrating:

The Lufran fluoropolymer inline water heater is shipped in a
horizontal position. The unit must be raised to a vertical
orientation before it can be removed from the shipping crate.
1) Inspect the shipping crate for evidence of damage. If any
damage is detected, contact the carrier immediately.
2) Inspect the shock sensors located on the outside of the crate.
The shock sensors will indicate if the unit experienced rough
handling. If the sensors indicate that the unit has experienced
rough handling, contact the carrier immediately.
3) Secure crate with adequate straps and carefully lift into a
vertical position.
4) Remove one side of the crate.
5) Remove any protective packaging material and any other materials that may have been packed in the
crate with the enclosure.
6) Remove any braces used to hold the unit in place during shipping.
7) Using a fork truck or other suitable lifting device, lift the unit from underneath and remove from the
crate.
8) Visually inspect the unit itself for damage. If there is evidence of damage, notify Process Technology
and the freight carrier immediately.
Ne pas incliner l'appareil au-delà de 10 ° à la
verticale. blessures ou des dommages matériels
graves peuvent en résulter.
M-43-25
Revision - Date 03-01-04-18
Due to the weight of the unit, DO NOT ATTEMPT
to move or lift the unit without the appropriate
material handling equipment.
Figure 20: ShockWatch Sensor
Do not tip the unit beyond 10° from vertical.
Serious personal injury or equipment damage may
result.
32
LUF-Series Lufran Manual
Standard outlet, Standard Interface