HYOSUNG MONiMAX8100QTN Operator's Manual page 54

Chapter4. Receipt Printer (SPR60)
► Problems during paper output
Problems
The printer stops printing
and warns errors during
printing.
<Note!> Contaminated paper may cause detection failure.
► Other problems
Problem
LED does not light and
printer does not work.
The printer does not work
after receiving
commands.
<Note!> Paper near end alarm acts only as a prompt for users, not an error status. Therefore when
this alarm is given, printing task can still be sent.
4-16
Paper end;
Paper jams in cutter; Dust or
wastepaper covers the paper
near end sensor.
<Problems during paper output>
The printer is not connected
with the power correctly.
The printer isn't turned on.
Printer is in error status. The
communication cable is not
connected well. Interface
setting is wrong.
© Hyosung TNS Inc. All Rights Reserved.
Possible reasons
Possible reasons
<Other problems>
Operator Manual
Solutions
Install a new paper roll;
Check if there are sundries in
cutter path;
Clean the paper near end sensor.
Solutions
Connect the printer with power
correctly.
Turn on the printer.
Remove the errors(＊)
Make sure the communication
cable is connected correctly.
Set the interface again according
to the self-test page.