HYOSUNG MONiMAX8100QTN Operator's Manual page 46

Chapter4. Receipt Printer (SPR60)
1
3
5
7
9
Note: The power cord connected with power interface 7 has power.
2. Modules of print unit
● Feed/Cut button
- Print self-test page: keep pressing the FEED button while turning on the power for 1s, the printer
will print the self-test page;
- Feed paper: under normal conditions, press the FEED / CUT button, the printer will feed paper, and
the printer will stop feeding paper when release the FEED / CUT button. During paper feeding, the
Presenter will start when the paper head enters the Presenter, and the Presenter will stop running
when the paper head is held by the Presenter;
- Cut paper: the printer will cut paper if press the FEED / CUT button for two times continuously.
Notice:
The printer will not run when press the FEED button under error status.
● Button for opening and closing the top cover
After pressing the button for opening and closing the top cover, the top cover module can be opened
for maintenance work, such as clear jammed paper jam, clean the print head/platen rollers.
● Power switch
Press "O" to turn off the power, or press "—"to turn on the power.
● Error LED (Red)
Indicate different status of printer. Normally, it is off; under error status (like paper end), it will flash.
Note: Error LED also flashes when the printer executes macro definition.
● Power LED (Green)
Indicate whether the power is on or not and it is always on when the printer is turned on.
Heating:
The print head and the motor gives out heat while using, please do not touch it just after operation.
4-8 © Hyosung TNS Inc. All Rights Reserved.
Feed/Cut button
Power LED
Paper guide block
Power interface
Paper entry
2 Error LED
4 Paper near sensor socket
6 Communication interface (USB or serial
interface is optional)
8 Button for opening and closing the top
cover
Operator Manual