HYOSUNG MONiMAX8100QTN Operator's Manual page 43

Operator Manual
2. Recommended marked paper:
The marked paper should meet the following requirement besides that of standard paper:
● Mark position
Notice:
Due to the dithering during paper feeding and tolerance of paper parameters, the mark positioning
position may have a tolerance of ± 1mm.
Only one mark sensor is mounted on the non-thermal side when the printer is delivered from the
factory (default position is on the non-thermal side of paper path) and the mark sensor position is
continuously adjustable.
- There are three positions for mounting the mark sensor on the thermal side, and the left and
the right positions can be adjusted along with the paper guide block while the middle position
is fixed. The position for mounting the mark sensor on the non-thermal side is continuously
adjustable. The above mark sensor has requirements for the mark position, referring to the
figure below;
- In using marks, it is recommended to use the following parameter:
L1 mark width: 8mm≤L1≤paper width
L2 mark width:: 4mm≤L2≤8mm
- The reflectivity of marks is less than 15%; The reflectivity of other part of the ticket within mark
width along paper feed direction is over 75%.There should not be any characters, graphics as
advertisement between marks space
© Hyosung TNS Inc. All Rights Reserved.
<Mark position diagram>
Chapter4. Receipt Printer (SPR60)
4-5