Using Channel Scan - One for All DVD EXPERT URC-4041 User Manual

IMPVE4P manual 1.0 4/11/03
3. Press
DVD/VCR
The
LED
4. The
AUX
control your second DVD player. See
Programming Device Control on page 9.
To re-assign other device keys to the
steps 1 through 4 with a sequence from the below chart:
NOTE: Only one device can be assigned to an unused device
key at a time.
To Re-Assign Device
AUX as 2nd TV key:
as 2nd
AUX CBL/SAT
When a re-assignment is done, the
to confirm your choice.At that time, you will need to
program the remote control for the new device (see
Programming Device Control on page 9).

USING CHANNEL SCAN

In the ,
DVD/VCR CBL/SAT
start a 3-second scan of all channels. If programmed,
use the key to scan only your favorite channels to
FAV
view a desired channel (see Programming Favorite
Channel Scan on next page. )
1. If Favorite Channel Scan has been set up,
skip to step 2. Otherwise, press
CBL/SAT
2. Press
FAV
• If Favorite Channel Scan has been set up,
scanning of favorite channels will start
and cycle through stored channels for
3 minutes or until stopped by pressing
any key.
• If Favorite Channel Scan has not been
set up, scanning will start with the
current channel, then proceed to the
next channel up and cycle through all
channels for 3 minutes or until stopped
by pressing any key.
3. To stop scanning channels at any time,
press any key once.
4:34 PM Page 15
once, then press
AUX
will blink twice.
key is now ready to be set up to
key, repeat
AUX
Perform Sequence
SET - 9 - 9 - 2 - TV - AUX
key: - - - -
SET 9 9 2 CBL/SAT
will blink twice
LED
, or mode, use the
TV FAV
DVD/VCR
, or once.
TV
once.
15
once.
-
AUX
key to
,