IMPVE4P manual 1.0
4/11/03
4:34 PM
Page 12
PROGRAMMING A MASTER POWER MACRO
In its default state, the
key on the One For All
POWER
DVD Expert Universal Remote Control will individually
power your home entertainment devices on or off.
However, you can also program a Master Power Macro
onto the
key that will sequentially turn on or off
POWER
all the devices with a single key press.
Programming The Power Key For The Master
Power Macro
1.
Press and hold
until the
(red light)
SET
LED
blinks twice, then release
.
SET
2.
Enter
-
-
. The LED will blink twice.
9
9
5
Then press
once.
POWER
3.
For the first device you want in the power-
on sequence, press its device key (e.g.,
) once.
CBL/SAT
4.
Repeat step 3 up to three more times to
add desired devices to the power-on
sequence.
5.
To save the settings and exit the program,
press and hold
until the
blinks
SET
LED
twice, then release
.
SET
Operating The Master Power Macro
1.
After programming, point the remote
control at the devices and press
POWER
for at least 2 seconds to sequentially turn
on or off your devices.
NOTE: When POWER is pressed for less than
2 seconds, a power command will only be sent
to the currently-selected device. This allows you
to still individually power devices on or off.
2.
You will see the devices turn on or off
according to your programmed sequence.
NOTE: The currently-selected device will always
turn on or off first, followed by the remaining
programmed sequence. After the master power
sequence has been completed, the remote control
will be set to control the first powered-on device.
NOTE: If one or more devices does not have a
POWER key, the power off/on sequence may be
slightly delayed when the remote control signals
the device(s). This action is normal.
Page 12