Checking The Codes - One for All DVD EXPERT URC-4041 User Manual

IMPVE4P manual 1.0 4/11/03
4. Aim the remote control at the TV and
slowly alternate between pressing
and
TV
pressing
NOTE: In the search mode, the remote control
will send IR codes from its library to the selected
device, starting with the most popular code first.
5. To lock in the code, press and release
The LED
6. To search for the codes of your other
devices, repeat steps 1 through 5, but
substitute the appropriate device key for
the device you are searching for.

CHECKING THE CODES

If you have set up the remote control using the
Searching For Your Code procedure (on the previous
page), you may need to find out which four-digit code
is operating your equipment.
For example,to find out which code is operating your TV:
1. On the remote control, press
2. Press and hold
blinks twice, then release
3. Enter
9
4. To view the code for the first digit, press
once.Wait 3 seconds, count the LED
blinks (e.g., three blinks = 3) and write
down the number in the leftmost box in
the TV code boxes on page 10.
NOTE: If a code digit is "0", the LED will not
blink.
5. Repeat step 4 three more times for
remaining digits. Use
digit,
3
fourth digit.Write down the code digits in
the remaining TV code boxes on page 10.
6. To check for codes of other devices, repeat
steps 1 through 5, but substitute the
appropriate device key for each device you
are checking.Write down the device's code
digits in the appropriate code boxes on
page 10.
4:34 PM Page 11
POWER
. Stop when the TV turns off (after
).
POWER
will blink twice.
once.
TV
until the (red light)
SET LED
.
SET
- - . The will blink twice.
9 0 LED
for the second
2
for the third digit, and for the
4
11
.
SET
1