Programming Device Control - One for All DVD EXPERT URC-4041 User Manual

IMPVE4P manual 1.0 4/11/03

PROGRAMMING DEVICE CONTROL

The One For All DVD Expert Universal Remote Control
is preprogrammed at the factory to operate an RCA TV,
a Toshiba DVD player, a Motorola cable box, and a
Pioneer audio receiver/amplifier. To control devices other
than the default brands, perform the following steps;
otherwise skip this section:
1. Turn on a desired device (e.g.,VCR or
DVD player) and, if applicable, insert
media (e.g., cassette or disc).
NOTE: Please read steps 2 through 4 completely
before proceeding. Highlight or write down the
codes and device you wish to program before
starting step 2.
2. On the remote control,press a device key
once (i.e.,
NOTE: To program control of a DVD device,
VCR, PVR (or DVR), VCR/DVD Combo, or
Home-Theater-In-A-Box device, press
DVD/VCR once.
NOTE: To program control of an Audio
Amplifier or Receiver, press AUX once.
NOTE: To program control of a Cable Box,
Satellite Receiver, or a Satellite Receiver/PVR
(or DVR) Combo, press CBL/SAT once.
NOTE: To program control of a TV/VCR Combo,
press DVD/VCR once. After programming, you
will be able to control channel selection, volume,
and VCR functions.
NOTE: To program control of a TV/DVD Player
Combo, press DVD/VCR once. After program-
ming, you will be able to control channel
selection, volume, and DVD functions.
3. Press and hold
blinks twice, then release
4. Use the Manufacturer's Codes (starting on
page 18) to locate the type of device and
brand name and then enter the first four-
digit code for your device. If performed
correctly, the
NOTE: If the LED did not blink twice, repeat steps
2 through 4 and enter the same code again.
4:34 PM Page 9
, , ,or ).
DVD/VCR AUX CBL/SAT TV
until the (red light)
SET LED
SET .
will blink twice.
LED
continued on next page...
9