Operating The Printer; Inserting Paper - Braillo 300 S2.1 User Manual

BRAILLO
l
4.

OPERATING THE PRINTER

4.1

Inserting paper

Paper should be inserted into the printer in the following manner:
1. Place a box of paper at the back of the printer. (Opposite side from the operating panel).
2. Insert the paper between the two paper guides, and then through the slit in the paper guide.
Insert about the length of one sheet. Go to the front of the printer.
3. The tractors might have to be adjusted sideways to fit to the paper width in use. This is done
by opening a little lever on the outer side of the tractors, then move the tractors so it will fit to
the paper width, then close the lever again.
4. Lock the paper into the tractor-feed. By using the FINE ADJUST button, adjust the paper with
respect to the starting mark (notch) corresponding to the chosen sheet length. (See figure
below).
5. Go to the back of the printer, and adjust the two paper guides carefully close to the edge of
the paper. This is to ensure that the paper will go straight through the printer.
The printer is now ready to start printing.
Note! If the printer has run out of paper during a print job, perform step 2 to 5, without re-
setting the printer. Press the "Continue" button, and the printer will continue from the place
where it ran out of paper without losing any text.
Adjust the tractors sideways to corre-
spond with the paper width in use, and
so that the margins are suitable
Use the marking that corresponds
to the sheet length in use
B 300 S2.1
29