Unpacking - Braillo 300 S2.1 User Manual

BRAILLO
l
2.1

Unpacking

Unpacking and installation can be done by the user.
Any kind of lifting of the printer must always be done from the base at the bottom of the printer, and
should be done with extreme care.
Make sure that your Braillo printer has not been damaged in transport. Check if the packing is dam-
aged; If so, it is possible that the printer has also been damaged or scratched. If any damages are
found, please contact your distributor or Braillo Norway AS immediately.
Also check that the printer is accompanied with the following items:
• Power cable for the printer
• Data cable, USB
• Data cable, ethernet (shielded)
• A small stack of paper
• User's guide
• Tool kit for service and maintenance
• Test and packing list
If any of these items are missing, please contact your distributor or Braillo Norway AS.
Important !
It is very important that the printer's specified voltage value, 230V, +/- 10%, corresponds with the
local mains power supply available.
If the plug on the mains power cable is to be replaced, note that the yellow/green wire is the ground-
ing (earthing) wire.
THE PRINTER MUST ALWAYS BE CONNECTED TO GROUND!
After the printer is unpacked, we advice that the transport box is stored for possible later use.
10
B 300 S2.1