Connecting The Printer To The Mains - Braillo 300 S2.1 User Manual

BRAILLO
l
2.5

Connecting the printer to the mains

The connection for the mains inlet is placed on the electric unit inside the printer.
It can be reached by removing the side panel on the opposite side from the operator panel.
Put the mains cable through the oval opening in the bottom plate just below the inlet on the electric
unit.
Connect the enclosed mains power cable to the Mains inlet.
Note! If the plug on the mains power cable is to be replaced with one that is compatible with the
local electric contact points, observe that the yellow/green wire is the grounding (earthing) wire. Also
make sure that you are connecting to 230 volts!
THE PRINTER'S MAINS CABLE MUST ALWAYS BE CONNECTED TO GROUND!
Mains inlet
Fans outlet
14
Power switch
B 300 S2.1
Safety switch