Connecting The Printer To The Computer - Braillo 300 S2.1 User Manual

BRAILLO B 300 S2.1
l
2.6

Connecting the printer to the computer

This can be done in three ways, either by Ethernet, USB, or WLAN.
For USB and Ethernet, the connections are placed behind and above the operator panel inside the
printer. They can be reached by removing the panel on the operator panel side. Put the cable(s)
through the oval opening in the bottom plate just below the electric unit.
The ethernet input is a regular RJ45 connector, and the USB input is a regular USB type B connector.
The WLAN is transmitting/receiving via a small antenna placed close to the operator panel.
When connecting with the USB or the ethernet cable, make sure the end with the ferrite bead is con-
nected to the printer.
Ferrite bead
If you connect to the computer with cable, there is no need to select between USB or Ethernet. The
printer will connect to the input who receives data first. Meaning, if data comes on the ethernet, the
USB will not be operative before the ethernet have finished the transmission.
For instruction on how to install the printer on your computer, see chapter 3 'SETTING UP THE COM-
PUTER' on page 18.
USB type B
Ethernet
15