BRAILLO
B 300 S2.1
l
2.2
The Braillo S2 Stand option
The B300 S2.1 can optionally be delivered with the Braillo S2 Stand.
If that is the case, you have to add the wheels under the Stand.
Place the wheels under the printer, one in each corner. This can be done simplest by carefully sliding
the printer on the pallet so just one corner comes outside the pallet. Fasten the wheel. Then slide the
printer so the next corner comes outside the pallet etc. Make sure you are at least two persons while
doing this!
Note! Do not lay the printer on the side to mount the wheels!
11