Advertisement
Quick Links
Elective Elements Gate Leg
SQUARE DRIVE
.125" DIA
GATE LEG
GLIDE ADJUSTMENT
WRENCH
If you have a problem, question, or request, call
your local dealer, or Steelcase Line 1 at
888.STEELCASE (888.783.3522)
for immediate action by people who want to help you.
(Outside the U.S.A., Canada, Mexico, Puerto Rico,
and the U.S. Virgin Islands, call: 1.616.247.2500)
Or visit our website: www.steelcase.com
© 2015 Steelcase Inc.
Grand Rapids, MI 49501
Page 1 of 7
U.S.A.
939568007 Rev B
Printed in U.S.A.
Advertisement
Related Manuals for Steelcase Elective Elements Gate Leg
Summary of Contents for Steelcase Elective Elements Gate Leg
- Page 1 GATE LEG GLIDE ADJUSTMENT WRENCH If you have a problem, question, or request, call your local dealer, or Steelcase Line 1 at 888.STEELCASE (888.783.3522) for immediate action by people who want to help you. (Outside the U.S.A., Canada, Mexico, Puerto Rico, and the U.S.
- Page 2 Assemble Gate Leg Carefully turn table top over onto clean, soft surface. Remove brackets and screws from hardware package. Attach brackets to legs. Ensure that the channel in the bracket faces up (toward the thick plate). Use the 8-32 x .375" tri-lobe screws to attach the brackets at pilot hole locations.
- Page 3 Assemble Gate Leg Slide the crossbeam over the brackets. Ensure that it is tight to the legs. Use the #8 x .375 flat head screws with washers to attach the cross beam to the brackets. Tip: Make sure that the torque control drill is set properly to prevent stripping of screws.
- Page 4 Turn leg frame over and attach the trim strip to the legs, making sure it is tight to each leg. Use #8 x .375 FOR BLADE EDGE WORKSURFACES ONLY: flat head screws to attach the trim. The outer surface of the gate leg must be inset from the edge of the worksurface by 3/4"...
- Page 5 Assemble Legs to Top Position the leg assembly on the top. Align holes in mounting bracket to holes drilled in top. Attach using the #10 x 1.5" flat head screws, (quantity - 10 per mounting bracket). Tip: To prevent damage to Carefully turn top and leg assembly legs use a long extension over.
- Page 6 Back to Back Applications Only Clamp the individual leg to the assembled leg ensuring that both legs are aligned in all directions. Using the existing holes in the individual leg as a template, drill through into the assembled leg using a .125" drill bit. (Depth not to exceed 1.375"). Attach the bracket and individual leg to the assembled legs using two (2) 8-18 x 1.250"...
- Page 7 Back to Back Applications Only Finish attaching crosspiece, opposite leg and trim per instructions Add worksurface, ensuring it's aligned to the other worksurface in all directions and attach to legs using ten (10) #10 x 1.500" flat head screws per bracket. Attach (2) tie plates to underside of worksurfaces using supplied screws.