Reset Procedure - Bionaire BWM0400 Instruction Leaflet

3) Push + and - together.
3.1) Unit remains off.
3.2) "timer" and "auto - high" turns on and
flashes on the remote, and 1 Hr appears
on the screen
4) Push + or - to adjust the number of hours that will
pass before it turns itself on.
4.1) you can choose from; 1to16 hours
4.2) 1 through 16 will scroll in a continuous loop
5) The whole screen flashes for 5 seconds after last
button push of + or - then goes back to previous mode
5.1) The timer will turn the unit on and run for
2 hrs. During the 2 hours, the digital
humidistat will maintain the room in
auto – high at the default of 45%.
6) At any time if you unlock the remote and push
the mode button on the remote the timer setting
will be erased and "timer" will disappear from the
screen.
7) To check how much time is remaining, press and hold
the + and – buttons simultaneously.

RESET PROCEDURE

Note: When the water tank is empty and the water tank
in the Heating Chamber is almost empty, the Automatic
Shut Off will activate. The RESET light will illuminate and
the unit will not operate again until you refill the water
tank and reset the humidifier.
1. Turn the unit off.
2. Unplug the unit.
3. Remove and refill the water tank, being sure to follow
the Daily Maintenance Instructions. Replace the tank
onto the base.
4. After the 5 minutes, plug in the unit and turn the unit
to High. The RESET light should now be off (if not
repeat steps 1 through 4). In about 2-3 minutes,
the humidifier will begin to produce moisture.
If the RESET light is still on at this point, and the unit
does not begin to product moisture within a few minutes,
then repeat Steps 1-4.
8