Timer Function - Bionaire BWM0400 Instruction Leaflet

1. Press the Mode button on the unit. The unit
will then switch "Modes"; either from "Low" to
"High" or "High" to "Off". The unit's lights will
reflect the change. The Remote will display a
different mode – the mode in which it was left.
If a button is pressed on the Remote, the
Remote's signal will override the "Mode" on
the unit and the two will be back in sync.

TIMER FUNCTION:

Using Timer to Turn Unit Off
1) Hold mode button for 2 seconds to unlock remote.
2) Push + and - together.
2.1) "timer" turns on. 1 Hr appears on the
screen.
3) Push + or - to adjust the number of hours the unit will
run before it automatically shuts itself off.
3.1) you can choose from; 1 to 8 hours
3.2) 1 through 8 will scroll in a continuous loop
4) After you have made your selection, the whole screen
flashes for 5 seconds after last button push of + or -
then goes back to previous mode
4.1) "timer" remains lit to show the timer function
has been set.
5) At any time if you unlock the remote and push
the mode button to turn the unit off the timer
setting will be erased and "timer" will disappear
from the remote.
6) To check how much time is remaining, press and hold
the + and – buttons simultaneously.
Using Timer to Turn Unit On
This function is meant for a person to pre-humidify a
room by setting the timer. For Example: It's 8 am, and
you want to come home to a humidified room at 8 pm.
To accomplish this place the unit in the desired room and
set the timer to turn the unit on in 12 hours. Once the
timer is activated the unit will run for a preset time of 2
hours.
1) Hold mode button for 2 seconds to unlock remote.
2) DO NOT push mode again as this will turn unit on.
7