Storage Instructions - Bionaire BWM0400 Instruction Leaflet

2.Remove the protective bag from the new filter and install
the filter into the base (see Figure 1). Replace the tank,
and plug the cord into the electric outlet. When installing
the filter for the first time, wait 15 minutes for the water to
flow through the filter before switching the unit ON.
You can obtain a new filter by calling 1-800-788-5350.
This humidifier takes model WMF50 replacement filter.
DISINFECT TANK:
1. Fill tank with 1/2 teaspoon of chlorine bleach and 1/2
gallon of water.
2. Let the solution stand for 20 minutes, swishing every
few minutes. Wet all surfaces.
3. Empty the tank after 20 minutes, and rinse well with
water until the bleach smell is gone. Dry with a clean
cloth or paper towel.
4. Refill the water tank with cool water; replace the housing
and water tank. Repeat ALL Operating Instructions.

STORAGE INSTRUCTIONS

If your humidifier will not be in use for two days or more, or
at the end of the season follow these instructions.
1. Clean and dry the humidifier thoroughly as per the
"Weekly Maintenance" instructions.
2. Let the humidifier dry completely before storing. Do not
store with water inside the base or water tank.
3. Remove the tank cap. Do not store with the
tank cap in place.
4. Store in a cool dry location.
Fig 4
Trouble Shooting for your Warm Mist Humidifier
Probable Cause
Trouble
• Power light not illuminated. Unit not plugged in.
Power failure.
• "Reset" light illuminated. Water tank empty.
Unit not reset after refill.
• Moist output low. Scale build-up in
tray.
Scale build on heating
element.
11
Solution
Plug in unit.
Check circuit breaker or
outlet.
Remove and refill tank.
Follow reset
instructions.
Remove tray and flush
out scale residue.
Remove scale from
heating element.