Filling The Water Tank - Bionaire BWM0400 Instruction Leaflet

PRE-OPERATING INSTRUCTIONS
1. Be sure the humidifier is switched off and
disconnected from the electrical outlet
2. Select a location for your humidifier, on a flat surface,
about 4" away from the
wall. Do Not place your
humidifier on furniture, a
floor location that will not
be damaged by moisture
is best.
3. Remove the water tank
by holding the tank
handle and lifting straight
upwards.

FILLING THE WATER TANK

1. Twist off the water tank cap located on the bottom of
the water tank by turning counter clockwise and fill the
water tank with cool fresh water. Do not fill with warm
water as this may cause leaking.
2. After filling the water tank, replace the water tank cap
by firmly turning clockwise and then replace the water
tank onto the base. The water tank will immediately
begin to empty into the base.
FIRST USE ONLY
1. Put batteries into Remote. The "Room" humidity will be
displayed at all times. (Use 3 AAA Alkaline batteries
only, do not mix batteries)
2. Plug unit into outlet. The first time the unit is plugged
in, it will beep every two seconds until it is synced with
the remote. To sync unit with remote follow the below
steps:
Unlock remote. (This must be done before each use of
the remote) To Unlock remote, hold down the mode
button for 2 seconds until the lock symbol
on the screen. Once the remote is unlocked, press the
mode button again and the unit will quickly beep 5 times
telling the user the signal was received. If you have more
than one humidifier, DO NOT SYNC more than 1 unit
at once.
Battery Replacement: If the batteries are running low
on power, a low battery indicator
Fig 1
Control Panel
Humidifier
Housing
Tank Handle
Water
Reservior
Water
Tank
Safety
Purification
Lock Tab
Filter
disappears
will appear on the
4