Reset Procedure; Operating Instructions - Bionaire BWM5850DN-CN Instruction Leaflet

F E AT U R E S - O P E R AT I O N S
use, pour designated humidifier medication into the tray and
then turn on your humidifier as directed.
NOTES:
• DO NOT add medication to the water tank.
• DO NOT add medication to the medicine tray when the
unit is already operating.

OPERATING INSTRUCTIONS

IMPORTANT:
1. Press the Power Button ( ) to switch on the unit.
NOTE: This humidifier is featured with rapid steam.
After powered on, the humidifier will begin to mist
within 1 minute. A boiling noise is normal. To
minimize the noise level, operate the unit at low setting.
* Visible mist under 1 minute was measured
using water at an average temperature of
.
65°F (18°C)
2. After the unit begins misting, the humidifier will run
at High Setting (indicator light of "2" will illuminate).
Press the Mist Button (
Setting (indicator light of "1" will illuminate).
3. To switch the humidifier off, press the Power Button
until all indicator lights go off.
WARNING: DO NOT move the humidifier with water in
Figure 1
C
A
G
A. Humidifier Tank
B. Humidifier Housing
C. Power Button ( )
) to switch to the Low
F
E
D
B
D. Mist Button ( )
E. Hi/Lo (1, 2) Indicator Lights
F. Medicine Tray
G. Humidifier Base
the tank or the humidifier base. The moving action of the
water may activate the water tank's release nozzle and
overfill the humidifier base. This may cause the
humidifier to function intermittently, or stop emitting
mist. Should this occurs, simply remove the excess water
from the humidifier base.

RESET PROCEDURE

When the water in the tank is empty and the water in the
heating chamber is almost empty, the Automatic Shut Off
will activate to prevent overheating. The indicator lights
will blink and the humidifier will stop operation until the
water tank is refilled and humidifier is reset as below:
1. Unplug the unit to switch it off.
2. Remove and refill the water tank, follow the "Daily
Maintenance" and Pre-Operating Instructions to clean
and refill the water tank. Replace the tank onto the unit.
3. Allow 15 minutes for the Automatic Shut off to reset.
4. After 15 minutes, plug in the unit and switch ON the
humidifier to begin operation. Within 1 minute, the
unit will begin to produce moisture. If the unit does
not start working, it is still too hot. Unplug the unit,
wait 15-30 additional minutes, plug the unit back in.
The unit should now be cool enough and operate
normally.
Control Panel
C
E
D