Bionaire BWM0400 Instruction Leaflet page 7

HUMIDISTAT OPERATION WITH REMOTE
1. Press Mode button on remote until the remote screen
displays "Auto" and "low". The "Set" humidity is
displayed next to the "Room" humidity. The "Auto"
light on unit will illuminate. The unit will cycle on and
off to maintain the "Set" humidity.
Note: The default room humidity = 45%. In this mode
the unit will run to maintain the "Set" humidity.
2. Press Mode button on remote again for "High" and
"Auto". The unit will cycle on and off to maintain the
"Set" humidity.
3. To turn unit "Off", press the Mode button and the LCD
will go blank (except for the "Room" humidity display
which is always displayed while batteries are in the
remote) and the unit will shut off.
Note: It is normal for the humidifier to cycle on and off
as it maintains the preset humidity.
Adjusting Set Humidity:
1. When in "Auto" mode, press the (+) or (-) buttons on
the remote. The "Set" number will increase or
decrease with each press. Hold the button down to
scroll. The minimum humidity is 35% and the
maximum is 60%. The unit scrolls one digit at a time in
a continuous loop. 35%, 36%..., 59%, 60%, 35%,
36%....
UNIT OPERATION WITHOUT REMOTE
Your humidifier can be operated directly from the control
panel located on the top of the unit
A. Remote and Unit are OFF:
1. Press the Mode button on the unit the first
time. The "Low" light illuminates and the unit
runs in "Low" mode. The power light turns on.
2. Press the Mode button again to run in "High"
mode.
3. Press the Mode button again and the unit
shuts off.
Note: The "auto" light only illuminates when the unit is set
to "auto" mode by the remote.
B. Remote is ON and Unit is ON:
6