Page 1
WARM MOISTURE digital humidifier BWM0400 MODEL Read instructions before operating. Retain for future reference. Instruction Leaflet INFO-LINE If after having read this leaflet, you have any questions or comments on your humidifier, call 1-800-788-5350 in North America.
11. Use appliance only for intended household use as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or injury to persons. The use of attachments not recommended or sold by Bionaire ® may cause hazards.
Page 3
20. Do not use humidifier in an area where humidity level is in excess of 50%. Use a hygrometer, available at your local hardware store or through Bionaire, to measure the humidity. 21. DO NOT attempt to repair or adjust any electrical or mechanical functions on this unit.
HOW YOUR WARM MOISTURE HUMIDIFIER WORKS Your Bionaire ® Warm Moisture humidifier is designed to allow the proper amounts of water to flow out of the tank. Air is drawn in through the grill openings and mixed with steam in the misting chamber.
PRE-OPERATING INSTRUCTIONS 1. Be sure the humidifier is switched off and disconnected from the electrical outlet 2. Select a location for your humidifier, on a flat surface, about 4” away from the Fig 1 Control Panel wall. Do Not place your Humidifier Housing Tank Handle...
Page 6
remote. Low batteries will affect transmission distance and the screen contrast. We recommend replacing the batteries immediately. Remote Distance: The transmission distance for this remote is approximately 30ft. Do not use farther than 30ft. from the appliance. Remote must be used in same room as appliance.
Page 7
HUMIDISTAT OPERATION WITH REMOTE 1. Press Mode button on remote until the remote screen displays “Auto” and “low”. The “Set” humidity is displayed next to the “Room” humidity. The “Auto” light on unit will illuminate. The unit will cycle on and off to maintain the “Set”...
1. Press the Mode button on the unit. The unit will then switch “Modes”; either from “Low” to “High” or “High” to “Off”. The unit’s lights will reflect the change. The Remote will display a different mode – the mode in which it was left. If a button is pressed on the Remote, the Remote’s signal will override the “Mode”...
3) Push + and - together. 3.1) Unit remains off. 3.2) "timer" and "auto - high" turns on and flashes on the remote, and 1 Hr appears on the screen 4) Push + or - to adjust the number of hours that will pass before it turns itself on.
IMPORTANT: If you do not plan to use the humidifier for two or more days, make sure any residual water is drained from the water tank and base to prevent algae or bacteria growth. WARM MIST CLEANING AND MAINTENANCE INSTRUCTIONS The following maintenance procedures must be routinely followed in order to ensure proper, efficient operation of your humidifier.
to clean the Heating Element. Never use detergents, gasoline, kerosene, glass cleaner, furniture polish, paint thinner or other household solvents to clean any part of the humidifier. WEEKLY MAINTENANCE Remove scale: Allow to cool before maintenance. 1. Repeat steps 1-5 in the Daily Maintenance section. 2.
2.Remove the protective bag from the new filter and install the filter into the base (see Figure 1). Replace the tank, and plug the cord into the electric outlet. When installing the filter for the first time, wait 15 minutes for the water to flow through the filter before switching the unit ON.
3. Should your humidifier require service, please call 1-800-788-5350 in North America for further assistance. If you have any other questions or comments, feel free to write to us or visit our website www.bionaire.com The Holmes Group, Inc. Consumer Service Department 32B Spur Drive...
Page 14
FOR WARRANTY SERVICE, PLEASE CALL 1-800-788-5350 IN NORTH AMERICA. A Bionaire ® consumer service representative will help determine which is the best procedure in order for your humidifier to be repaired.