F E At U R E S - O P E R At I O N S; Consumer Safety Information; Filling The Water Tank - Bionaire BCM730-CN Series Instruction Leaflet

F E AT U R E S - O P E R AT I O N S

26. Do not move unit after it has been used until unit cools
completely.
27. Use both hands when carrying full tank of water.
PLEASE READ AND SAVE
THESE IMPORTANT SAFETY
INSTRUCTIONS

CONSUMER SAFETY INFORMATION

NOTE: This is an electrical appliance and requires attention
when in use.
NOTE: If moisture forms on the walls or windows of the
room, turn off the humidifier. The room already has plenty of
humidity and additional moisture may cause damage.
NOTE: DO NOT block air inlet or outlet.
Cord and Plug Installation Safety Instructions:
The length of cord used on this appliance was selected to
reduce the hazards of becoming tangled in, or tripping over a
longer cord. If a longer cord is necessary an approved
extension cord may be used. The electrical rating of the
extension cord must be equal to or greater than the rating of
the humidifier (refer to the rating information placed on the
humidifier). Care must be taken to arrange the extension cord
so that it will not drape over the countertop or tabletop where
it can be pulled on by children or accidentally tripped over.
HOW COOL MIST WORKS
Your Bionaire Cool Mist humidifier draws dry air through
®
the rear air intake grill area. This air is then passed through
a moisture–laden wick filter, which retains the minerals and
deposits in the water. The resulting moist air is directed back
into the room from the top air grill.
NOTE: This humidification system provides a cool, invisible
moisture output. It is normal not to see the mist.
NOTE: A humidity level below 20% can be unhealthy and
uncomfortable. The recommended humidity level is between
40%-50%.
PRE-OPERATING INSTRUCTIONS
1. Be sure the humidifier is switched to OFF and the unit is
disconnected from the electrical outlet.
2. Select a location for your humidifier, on a flat surface,
about 4 inches (10 cm) away from the wall. DO NOT
place the humidifier on a finished floor or near furniture,
which can be damaged by too much moisture or water.
Place on a moisture resistant surface.

FILLING THE WATER TANK

1. Remove the tank from the housing of the humidifier by
grabbing the handle of the tank and pulling forward. Lift
the tank out of the housing and bring to the faucet. Turn
the tank upside down and twist off the tank cap by
turning counter clockwise. Fill tank with cool, fresh tap
water. DO NOT fill with warm water as this may cause
leaking. Replace the cap on tank FIRMLY.
2. When full, carry the
tank to the humidifier
and place it into the
housing. To insert
tank into housing,
use the locating tabs
at the bottom of the
unit to line up the
base of the tank
evenly with housing
at a slight angle
(see Figure 1). Once
the tank is lined up
at the base, use the handle to push the top of the tank
into place. You will hear a click when tank is locked in
correctly. The tank holds 1.2 gallons of water. The tank
will immediately begin to empty into the base.
3. Plug the power cord into a 120V AC electrical outlet.
OPERATING INSTRUCTIONS
NOTE: The humidifier produces clean, cool, INVISIBLE
moisture. It is normal not to see the moisture.
1. Allow up to 30 minutes for the filter to fully absorb water
and the unit to produce the maximum moisture output.
2. Press the Power Button (
the humidifier will run at High setting and "3" will
illuminate on the display. After 2 seconds, the display will
return to show the room humidity.
3. If you want to switch to Medium/Low settings, press the Power
Button ( ) again. Each press of the button will cycle
Figure 1
) to turn the humidifier on,