Liability; Residual Risks - LOGICDATA DYNAMIC MOTION System Manual

2.5 LIABILITY

LOGICDATA products comply with all relevant industry standards, which are listed in the product's data-
sheet. However, risk can result from incorrect operation or misuse. LOGICDATA is in particular not liable for
damage or injury caused by:
• Improper product use
• Accidental usage
• Clear misuse/abuse of the Table System
• Disregard of the documentation
• Unauthorized product alterations
• Improper work on and with the Table System
• Operation of damaged products
• Normal wear and tear of the Table System or its components
• Wear parts
• Improperly performed repairs
• Unauthorized changes to the operating parameters
• Disasters, external influence, and force majeure
The information in this documentation describes the characteristics of the system without assurances.
Resellers assume responsibility for the LOGICDATA products installed in their applications. They must en-
sure their product complies with all relevant directives, standards, and laws. LOGICDATA shall not be held
liable for any damage that is directly or indirectly caused by the delivery or use of this document. Resellers
must observe the relevant safety standards and guidelines for each product in the Table System.

2.6 RESIDUAL RISKS

Residual risks are the risks that remain after all relevant safety standards have been complied with. These
have been evaluated in the form of a risk assessment. Residual risks associated with the operation of the sys-
tem are listed here and throughout this Operating Manual. The risks associated with mounting each product
to the Table System are detailed in the respective product's Operating Manual. The risks associated with con-
necting the products in the Table System are detailed in the DYNAMIC MOTION Configuration Handbook.
See also page 5. The symbols and signal words used in this Operating Manual are listed in Chapter 2.5 on
page 6.
Risk of death or serious injury in explosive atmospheres
WARNING
Operating the system in potentially explosive atmospheres may lead to death or serious
injury through explosions.
• Read the relevant directives to determine if an atmosphere is potentially explosive
• Do not operate the system in potentially explosive atmospheres
Moderate risk of serious injury through electric shocks
WARNING
While cleaning or using the system, liquid intrusion may lead to serious injury through
electric shocks.
• Do not allow any components to become wet during cleaning
• Ensure components are placed away from areas where spillages are likely to occur
• Take care not to spill liquids onto or around the system
Risk of injury through exposure to harmful gases
CAUTION
Operating the system using damaged cables may lead to overheating and the release
of harmful gases. Inhaling these gases may lead to minor or moderate injury.
• Do not use damaged CableS
• Ensure that Cables are not clamped during assembly
Risk of minor or moderate injury through crushing
CAUTION
If any Handset Key becomes stuck while the system is in motion, the system may not
stop properly. This may lead to minor or moderate injury through crushing.
• Disconnect the system immediately if any Handset Key becomes stuck
DYNAMIC MOTION SYSTEM - SYSTEM MANUAL // PAGE 7