Re-Assigning Device Keys - Universal Electronics Atlas CABLE 4 User Manual

Atlas Manual rev2 12/27/02

RE-ASSIGNING DEVICE KEYS

The Atlas Universal Remote Control can be set up to
control a second TV or VCR, or any combination of up
to four home entertainment devices. For example, to
have the unit control a TV, a Cable Converter, and two
VCRs, you will need to re-assign the unused AUD key to
operate the second VCR as follows:
1. On the remote control, press VCR once.
Then press and hold SETUP until the
VCR key blinks twice, then release SETUP.
2. Enter 9 - 9 - 2. The VCR key will blink twice.
3. Press VCR once, then press AUD once. The
AUD key will blink twice.
4. The AUD key is now ready to be programmed
for your second VCR. See Programming Device
Control on page 8.
To re-assign other device keys, repeat steps 1 to 4 and
substitute the key sequence using the following chart:
To Re-Assign Perform Key Sequence
TV as 2nd VCR key: TV - SETUP - 9 - 9 - 2 - VCR - TV
TV as 2nd Audio key: TV - SETUP - 9 - 9 - 2 - AUD - TV
TV as 2nd Cable key: TV - SETUP - 9 - 9 - 2 - CBL - TV
TV back to TV: TV - SETUP - 9 - 9 - 2 - TV - TV
VCR as 2nd TV key: VCR - SETUP - 9 - 9 - 2 - TV - VCR
VCR as 2nd Audio key: VCR - SETUP - 9 - 9 - 2- AUD - VCR
VCR as 2nd Cable key: VCR - SETUP - 9 - 9 - 2 - CBL - VCR
VCR back to VCR:
AUD as 2nd TV key:
AUD as 2nd Cable key: AUD - SETUP - 9 - 9 - 2 - CBL - AUD
AUD back to AUD: AUD - SETUP - 9 - 9 - 2 - AUD - AUD
Upon completion of a re-assignment, the selected mode
key will blink twice to confirm your selection. Then, you'll
need to program device control (see Programming Device
Control on page 8).
11:08 AM Page 25
VCR - SETUP - 9 - 9 - 2 - VCR - VCR
AUD - SETUP - 9 - 9 - 2 - TV - AUD
25