Re-Assigning Device Keys - Universal Electronics MillenNium 4 User Manual

Re-assiGninG DeViCe KeYs

The Millennium 4 can be set up to control a
second TV or VCR, or any combination of four
home entertainment components. For example,
to have the Millennium-4 control a TV, a Cable
Converter, and two VCRs, you will need to re-
assign the unused auDiO key to operate the sec-
ond VCR as follows:
1. On the Millennium 4, press and hold
seTuP until the LED blinks twice, then
release seTuP.
2. Enter 9 - 9 - 2. The LED will blink twice.
3. Press VCR once, then press auDiO once.
4. The auDiO key is now ready to be pro-
grammed for your second VCR. See
Programming VCR Control on page 12.
To re-assign other device keys, repeat steps 1
through 4 by substituting the key sequence from
the following chart for a desired component:
To Re-assign
TV as 2nd VCR key:
TV as 2nd Audio key:
TV as 2nd Cable key:
TV to TV:
VCR as 2nd TV key:
VCR as 2nd Audio key:
VCR as 2nd Cable key:
VCR to VCR:
AUDIO as 2nd TV key:
AUDIO as 2nd VCR key: SETUP - 9 - 9 - 2 - VCR - AUDIO
AUDIO as 2nd Cable key: SETUP - 9 - 9 - 2 - CBL - AUDIO
AUDIO to AUDIO:
Upon completion of a re-assignment, the LED will
blink twice to confirm your selection. At that time,
you will also need to program the Millennium 4 to
control the new component (see previous sections
on Programming TV Control, Programming
VCR Control, Programming Cable Control, or
Programming Audio Control).
Perform Key sequence
SETUP - 9 - 9 - 2 - VCR - TV
SETUP - 9 - 9 - 2 - AUDIO - TV
SETUP - 9 - 9 - 2 - CBL - TV
SETUP - 9 - 9 - 2 - TV - TV
SETUP - 9 - 9 - 2 - TV - VCR
SETUP - 9 - 9 - 2 - AUDIO - VCR
SETUP - 9 - 9 - 2 - CBL - VCR
SETUP - 9 - 9 - 2 - VCR - VCR
SETUP - 9 - 9 - 2 - TV - AUDIO
SETUP - 9 - 9 - 2 - AUDIO -AUDIO
40