Universal Electronics Atlas CABLE 4 User Manual page 10

Atlas Manual rev2 12/27/02
PROGRAMMING TV/VCR COMBO CONTROL
3. (continued)
NOTE: If the VCR key did not blink twice after enter-
ing the code's last digit, then repeat steps 2 through 3
and try entering the same code again.
If you've located a TV/VCR setup code that
works your TV/VCR Combo and a separate TV
code is also listed, you'll need to program this
code into the remote control to access volume
control (see Programming Device Control on
page 8).
4. Aim the remote control at your TV/VCR
Combo and press POWER once. The device
should turn off. If it does not respond, repeat
steps 2-3 (starting on the previous page), trying
each code listed for your brand until you find
one that works. If it still does not work, try
searching for the code (see Searching For Your
Code on page 20).
5. For future reference, write down each working
device code in the boxes below:
TV/VCR
TV (if used)
11:07 AM Page 10
10