Table of Contents
Advertisement
Atlas Manual rev2
12/27/02
TROUBLESHOOTING
PROBLEM:
Mode key does not blink when you press a key.
SOLUTION: Replace the batteries with two (2) new AA
alkaline batteries (see page 7).
PROBLEM:
Mode key blinks when you press a key, but home
entertainment device does not respond.
SOLUTION: Make sure you are aiming the remote control at
your home entertainment device and that you
are within 15 feet of the device you are trying
to control.
PROBLEM:
The remote control does not control home
entertainment devices or commands are not
performing properly.
SOLUTION: Try all listed codes for the device brand being set
up. Make sure all devices can be operated with
an infrared remote control.
PROBLEM:
TV/VCR combo does not respond properly.
SOLUTION: Use the VCR codes for your brand. Some combo
units may require both a TV code and a VCR
code for full operation (see page 9).
PROBLEM:
No volume on a second TV.
SOLUTION: Follow instructions in Changing Volume Lock
(see page 28).
PROBLEM:
CH+ , CH – , and LAST do not work for your
RCA TV.
SOLUTION: Due to RCA design (1983-1987), only the original
remote control will operate these functions.
PROBLEM:
Changing channels does not work properly.
SOLUTION: If original remote control required pressing
ENTER to change channels, press ENTER on the
remote control after entering a channel number.
PROBLEM:
Tried "Search Method" and still could not find a
working code.
SOLUTION: Try the "Search Method" again after clearing out
the device key as follows: Press and hold SETUP
until mode key blinks twice, then release. Next
enter 9 - 9 - 2. Then press and release the mode
key to be cleared twice.
PROBLEM:
Remote control does not turn on Sony or Sharp
TV/VCR Combo.
SOLUTION: For power on, these products require program-
ming TV codes on the remote control. For Sony,
use TV code 0000 and VCR code 0032. For Sharp,
use TV code 0093 and VCR code 0048.
11:08 AM
Page 30
30
Hide quick links:
Advertisement
Table of Contents
