• Check accessories and connection parts for possible damage prior to every use of the device. Do not use any defective devices or device parts. deep well pump TDP 370 E / TDP 750 E...
Page 3
• Provide appropriate frost protection. • Protect the power supply cable against heat, oil and sharp edges. Make sure that the power supply cable is not crushed, kinked or subjected to other mechanical stresses. deep well pump TDP 370 E / TDP 750 E...
Page 4
Not suitable for pumping potable water • have read and understood the instructions, especially the This symbol indicates that the device is not suitable for Safety chapter. pumping potable water. deep well pump TDP 370 E / TDP 750 E...
Page 5
Note If you store or transport the device improperly, the device may be damaged. Note the information regarding transport and storage of the device. deep well pump TDP 370 E / TDP 750 E...
Dirt strainer 3. Fully unwind the power cable. Make sure that the power cable is not damaged and that you do not damage it during Suspension eye unwinding. Power cable deep well pump TDP 370 E / TDP 750 E...
Page 7
Note If you want to connect a flexible hose as pressure line, do not use a suction hose or a non-pressure-resistant hose. Use pressure-resistant hoses only. deep well pump TDP 370 E / TDP 750 E...
Page 8
• in order to install and use the device in a permanent / stationary manner, use the pressure switch TDP DS • in order to install and use the device in a temporary / location-independent manner, use the pressure switch TDP DSP deep well pump TDP 370 E / TDP 750 E...
5. Store the device according to the Storage chapter. checked by a specialist company or by Trotec. • The water temperature is above 35 °C and the thermal protection circuit is activated. deep well pump TDP 370 E / TDP 750 E...
Your device still does not operate correctly after these checks? Please contact the customer service. If necessary, bring the device to an authorized specialist electrical company or to Trotec for repair. deep well pump TDP 370 E / TDP 750 E...
Pump weight 10 kg 11 kg Conditions for the pumping medium (water) Max. water temperature 35 °C Max. particle size 1.8 mm Max. chloride content 1.5 mg/l Max. hydrogen sulphide content 400 mg/l Min. pH Max. pH deep well pump TDP 370 E / TDP 750 E...
Page 12
Schematic representation Performance chart (delivery head / flow rate) TDP 370 E TDP 370 E max. 35° TDP 750 E TDP 750 E max. 35° deep well pump TDP 370 E / TDP 750 E...
Page 13
TDP 370 E / TDP 750 E Wiring diagram deep well pump TDP 370 E / TDP 750 E...
Page 14
Exploded assembly drawing deep well pump TDP 370 E / TDP 750 E...
• EN 60335-2-41:2003/A1:2004 • EN 60335-2-41:2003/A2:2010 • EN 61000-3-2:2014 • EN 61000-3-3:2013 • EN 62233:2008 Applied national standards and technical specifications: • AfPS GS 2019:01 • EN 55014-2:2015 • EN 60335-12012/A13:2017 deep well pump TDP 370 E / TDP 750 E...