Avaya S8700 Manual page 53

Figure 8: DS1 Converter Connections — Part 1
cydf010 KLC 091399
Figure notes
1 Port carrier/media gateway
2 Backplane connector for TN570D EI
3 Backplane connector for TN1654 DS1
Converter
4 50-pair female connector to EI
connector
Installing the circuit pack(s) in a port carrier
You install the TN1654 circuit packs in a port carrier in either an MCC1 or SCC1 media gateway in the
remote PN or in the central PN if the 2 slots in SNI are already used.
1
Install the TN1654 circuit pack in any slot in a port carrier close to a TN570D Expansion
Interface circuit pack.
2
On the backplane, connect a 14-inch (35.56 cm) Y cable from the TN1654 circuit pack to the
TN570D circuit pack. See
3
Connect an H600-348 Quad cable to the other side of the double-headed Y cable.
Adding New Hardware--S8700
November 2003
1
20 19 18 17 16 15 14 13 12 11 10 09
CAUTION:
When adding or replacing any hardware and associated cables and adapters, be sure to
ground yourself against electrostatic discharge (ESD) by wearing a grounded wrist strap.
DS1 Converter Connections — Part 1
NOTE:
The Y cable used with the TN1654 circuit pack is different than the Y cable used with the
old TN574 DS1 converter circuit pack. These cables are NOT interchangeable.
08 07 06 05 04 03 02 01
4
5 14-in. (35.6 cm) Y cable
6 50-pin male/50-pin female double-headed
connector
7 H600-348 Quad Cable (with 50-pin male
connector), which connects the Y cable to
the 4 CSUs, if used.
2
3
6
7
A
5
on page 53.
53