Avaya S8700 Manual page 19

7
Type in the following information:
•
•
•
•
•
•
•
8
Press Enter
9
Type add data-module next and press
add data-module next
Data Extension: 20010
Network uses 1's for Broadcast Addresses? y
10
Set the Type field to ethernet.
11
Set the Port field to correspond to the circuit pack location.
The port number (final two digits) is always 33 for the TN799DP circuit pack.
12
Set the Link field to an unassigned or next-available link number.
13
Set the Network uses 1's for Broadcast Address? field according to the your
network requirements.
14
Type a unique name in the Name field.
15
Press Enter
Refer to the Administration for Network Connectivity for Avaya Communication Manager (555-233-504)
for more information on these administration steps and for the steps to administer endpoints.
Test the external connection to the LAN
To test the external IP connections, ping the gateway and a known computer connected to the network. If
everything is configured correctly, you have a successful ping. If you cannot ping, verify the IP-address
information and check the connectivity, including the cabling.
To test the external IP connections, ping a computer on the same subnet, the gateway, and a computer
beyond the gateway. If everything is configured correctly, the Result column on the Ping Results
screen reads pass. If it reads abort, verify the IP-address information and check the connectivity,
including the cabling.
Adding New Hardware--S8700
November 2003
The Type, Slot, IP Address, and Code/Suffix fields are automatically populated.
In the Node Name field type the same node name entered on the Node Name screen.
In the Subnet Mask field use the default setting unless you are given a different subnet
mask.
In the Gateway Address field use the address you are given or leave blank.
Set the Enable Ethernet Port field to y
Set the Net Region field to 1 unless you are given a different number.
Set VLAN to n
to save the information and effect the new settings.
DATA MODULE
Type: ethernet
Port: 01All
Link:
to save your changes.
Install and Administer IP Connectivity Hardware
.
Enter
Name:C-LAN1
Page 1 of 1
19