Avaya S8700 Manual page 22

Install and Administer IP Connectivity Hardware
Install the cables
1
Determine into which port slots you are putting the TN2302AP IP Media Processor circuit packs.
From the rear of the media gateway:
2
Connect the amphenol connector on the adapter to the Amphenol connector corresponding to
each TN2302AP slot. Refer to
Figure 2: TN2302AP Amphenol Adapter
Figure notes
1 Amphenol connector to backplane
connector corresponding to
TN2302AP slot
3
Connect the network cable(s) to the ETHERNET connector on the TN2302AP backplane
adapter(s).
22
NOTE:
If installing the TN2302AP into an old carrier or cabinet, you must replace the WP cables,
which connect the backplane to the rear connector panel, with Twisted Pair I/O cables to
handle the 100 Mbps speed. Refer to
on replacing the wires.
TN2302AP Amphenol Adapter
3
addfipm2 KLC 083000
NOTE:
You need a CAT5 or better cable for 100-Mbps operation.
Replace the WP Cables
on page 22.
2
1
2 RJ45 LAN cable connection
•
10 Mbps uses CAT3 cable
•
100 Mbps uses CAT5 cable
3 9-pin connector for maintenance
Adding New Hardware--S8700
on page 29 for information
November 2003