Table of Contents
Advertisement
Installation Instructions - Dual Integrated Installation
STEP 9 FINAL EXTERNAL UNIT
PREPARATION (Cont.)
Install front mullion and access cover trims between
the 2 units. Open the doors and push the flexible
"dart" area of the trims in place between units.
"Dart"
STEP 10 INTERNAL UNIT
PREPARATION
Remove all tape, cardboard, and foam from each
unit.
Remove boxed door bins from shelves.
Unbox and install door bins.
Upper Mullion
Trim
"Dart"
Lower
Mullion Trim
16
STEP 11 START ICEMAKER
(freezer models)
CAUTION
Avoid contact with the moving parts
of the ejector mechanism, or with the heating element
(located on the bottom of the icemaker) that releases
the cubes. Do not place fingers or hands on the
automatic ice making mechanism while the freezer is
plugged in.
A newly-installed freezer may take 12–24 hours to
begin making ice.
The icemaker will produce seven cubes per cycle—
approximately 15 cycles in a 24-hour period,
depending on freezer compartment temperature, room
temperature, number of door openings and other use
conditions.
If the freezer is operated before the water connection
is made to the icemaker, set the power switch to
OFF. Top wire basket must be removed to access the
icemaker power switch.
When the freezer has been connected to the water
supply, set the power switch to ON.
Throw away the first full bucket of ice to allow the water
line to clear.
Be sure nothing interferes with the sweep of the feeler
arm.
(Appearance may vary)
Icemaker
Feeler Arm
Power
Switch
When the bin fills to the level of the feeler arm, the
icemaker will stop producing ice.
It is normal for several cubes to be joined together.
If ice is not used frequently, old ice cubes will become
cloudy, taste stale and shrink.
NOTE: Icemaker works best between 40 and 120 PSI
(275-827 kPa) home water pressure.
Icemaker
Feeler Arm
Power
Switch
31-49133-1
Advertisement
Table of Contents
