Step 7 Level Unit - Monogram ZIR300NPKII Installation Instructions Manual

Installation Instructions - Single Integrated Installation
STEP 6 INSERTING/SECURING INTO
CABINET SURROUND (Cont.)
As you walk the unit back, pull the anti-tip strap tight.
Secure the strap in the front of the unit.
Secure the strap in the front of the unit by replacing
the screw in the top strap bar (do not overtighten) and
the large tensioner screw to prevent the strap from
moving.
Replace the waterline strain relief screw.
Strain Relief
Screw
WARNING
Replace waterline strain relief in front rail location as
shown.
Store the excess strapping, string, and water tubing
under the unit.
31-49133-1
Anti-tip Strap
Electrical Shock Hazard.

STEP 7 LEVEL UNIT

All models have 4-point leveling. The front is supported
by leveling legs; the rear is supported by adjustable
wheels. Both are accessible from the front of the unit.
To level the back of the unit, turn the 7/16" hex nut
located above the front wheels. Turn clockwise to
raise or counterclockwise to lower the unit.
For front leveling, use a 7/16" open-end wrench.
Adjust height of unit to match installation cutout
opening 84". The unit should be level and plumb with
cabinetry.
Hex nut adjusts
rear wheels
NOTICE: The rear leveling wheels and front leveling
legs are limited to a maximum height adjustment of 1".
If the installation requires more than 84" height, the
installer should elevate the unit on a sheet of plywood
or runners. Cabinetry trim could also be added across
the top of the opening to shorten the opening. If you
attempt to raise the unit more than 1", you will damage
the front leveling legs and the rear leveling wheels.
37
Open-end wrench
adjusts front
leveling legs