The Installation Space - Monogram ZIR300NPKII Installation Instructions Manual

18” and 24”built-in column freezers 24” and 30” built-in column refrigerators
Table of Contents

Advertisement

Design Guide - Single Integrated Installation
SINGLE INTEGRATED INSTALLATION SPACE
Dimensions in parentheses are in centimeters.
18" Integrated Freezer
17 3/4"
(45.1)
84"
(213.4)
7 1/2 2
4 1/8"
(10.5)
6 3/4"
4"
E
W
(17.2)
(10.2)
3 1/2"
2 1/2"
(8.9)
(6.4)
FRONT VIEW
24" Integrated Freezer or Refrigerator
23 3/4"
(60.3)
84"
(213.4)
9 1/2"
4"
(24.1)
(10.2)
4 3/8"
(11.1)
6 3/4"
ELEC W
(17.2)
5"
2 1/2"
(12.7)
(6.4)
FRONT VIEW
Product Clearances
These units are equipped with a 2-position door stop.
The factory set 115° door swing can be adjusted to 90° if
clearance to adjacent cabinets or walls is restricted.
For a 90° door swing, allow 4" (10.2 cm) minimum
clearance to a wall.
When installed in a corner, allow 15" (38.1 cm) for a full
115° door swing on 18" and 24" models. Allow 16.5"
(41.9 cm) on 30" models.
25"
(63.5)
3 1/2"
(8.9)
Finished
Return
SIDE VIEW
25"
(63.5)
3 1/2"
(8.9)
Finished
Return
SIDE VIEW
30" Integrated Refrigerator
29 3/4"
(75.6)
84"
(213.4)
10 1/4"
6 1/4"
(26.0)
(15.9)
4 3/8"
(11.1)
6 3/4"
ELEC W
(17.2)
5"
2 1/2"
(12.7)
FRONT VIEW
Water And Electrical Locations
Electrical and water supply must be located as shown.
The Cutout Depth Must Be 25".
Additional Specifications
A 115 volt 60Hz., 15 or 20 amp power supply is
required. An individual properly grounded branch circuit
or circuit breaker is recommended. Install a properly
grounded 3-prong electrical receptacle recessed into
the back wall. Electrical must be located on rear wall as
shown.
Water line must be located on the back wall as shown.
The water line should be 1/4" O.D. copper tubing or
QuickConnect
kit (WX08X10006) between the cold
water line and water connection location, long enough
to extend to the front of the unit (8' [2.4 m]). Installation
of an easily accessible shut-off valve in the water line is
required.
A minimum of 3-1/2" (8.9cm) finished return matching
cabinet exterior is recommended on interior on all sides
and top at front of opening.
Installations with 4" (10.2 cm) or less between units
require Heater Kit ZUGC.
32
25"
(63.5)
3 1/2"
(8.9)
Finished
Return
(6.4)
SIDE VIEW
31-49133-1

Advertisement

Table of Contents
loading

Table of Contents