Table of Contents
Advertisement
Direct Extension Dial Delay (#112)
Direct Extension Dial Delay (#112)
Description
This System Programming procedure specifies the number of times (0–9) an
incoming call should ring before it is answered by the Direct Extension Dial
feature.
Related Features
Direct Extension Dial affects incoming calls only on lines identified using
Direct Extension Dial Lines (#205).
You must program a button on the system display phone at extension 10 to
turn Direct Extension Dial on and off. Use Direct Extension Dial Button
(#113) to program the button.
You must use Direct Extension Dial Record/Playback to record a
message to prompt callers to dial an extension number or Hunt Group
number after the system answers an outside call.
If you use Caller ID, make sure Direct Extension Dial Delay is set to 2 rings
or more to ensure that Caller ID information is captured.
Considerations
The Automatic System/Direct Extension Dial PC card is purchased
separately and must be installed. If the PC Card has not been installed,
see the PARTNER PC Card Installation Instructions .
Use the Direct Extension Dial Record/Playback feature to record a
message before using Direct Extension Dial since there is no default
message.
This feature works independently of Line Ringing, which determines how
an outside call rings at the extension—immediately, after a 20 second
delay, or not at all. Direct Extension Dial Delay specifies the number of
rings a caller hears before the system answers the call.
Valid Entries
0–9 (0 rings = answered immediately)
2
Programming
(See Figure 2-2 on page 2-19 for the location of special programming buttons
s
such as
To change the number of times an incoming call rings at extension 10 before the
system answers it:
1. Press
2. To change the number of rings, press
displays.
3. Select another procedure or exit programming mode.
e
and
on system phones.)
f 0 0 s s # 1 1 2
.
D
until the appropriate value
5-71
Advertisement
Table of Contents
