Mitsubishi FDT100VNXWVH Service Manual page 186

10. To remove the printed circuit board (PCB)
(1) Remove the service panel and top panel.
(3) Take off 6 control PCB fixing locking support and remove it.(
(4) Remove 5 plate fixing screws and open it.(
(5) Pull off all the inserted connectors of inverter PCB.(Pic. )
(6) Take off 9 inverter PCB fixing locking support and remove it.(
11. To remove the printed circuit board (PCB)
Hinge control type
(1) Remove the service panel.
(3) Take off 5 control PCB fixing locking supports and remove it.(
(4) Remove 2 plate fixing screws and open it.(
(5) Pull off all the inserted connectors of inverter PCB.(Pic. )
(6) Take off 6 inverter PCB fixing locking supports and remove it.(
9. To remove the compressor (CM)
(1) Remove the service panel.(See No.1)
(2) Remove the insula
(Strings (a) (d) should be loosen.)
(3) Remove 3 terminal cover fixing bolts(
remove it and disconnect the power wiring.
(4) Remove welded part of compressor by welding.
(
(5) Remove 3 compressor fixing nuts(
(2) Pull off all the inserted connectors of control PCB.(Pic. )
mark, Pic. )
(2) Pull off all the inserted connectors of control PCB.(Pic. )
mark, Pic. )
185
- -
which covers compressors.
mark)
or adjustable wrench.
mark, Pic. )
mark, Pic. )
mark, Pic. )
mark, Pic. )
'20 • PAC-SM-351
mark) and
mark) using spanner