Mitsubishi FDT100VNXWVH Service Manual page 180

Bottom panel
6. To remove side panel and bottom panel
(1) Remove air inlet grille.(See No.1)
(2) Remove the right and left side panel fixing
screws and remove it.(
(3) Remove 5 bottom panel fixing screws.(
Remove 6 bottom panel fixing screws and
remove it. ( mark, left and right side)
7. To remove drain pan
(1) Remove side panel and bottom panel.(See No.5)
(2) Remove 2 plate fixing screws and remove it.(
(3) Remove 2 support fixing screws and remove it.(
(4) Pull out the drain pan.
9. To remove the louver motor (LM)
(1) Remove the lid of control box.(See No.1)
(2) Disconnect the louver motor connector
(3) Remove side panel.(See No.5)
(4) Remove 2 louver motor fixing screws
Coil of EEV
PROCEDURE & PICTURES
mark)
mark)
mark, Pic. )
(CNJ) on PCB in control box.
and remove it.
11. To remove the Electronic Expansion Valve (EEV)
(1) Remove the heat exchanger assembly.(See No.9)
(2) Remove the coil of EEV by pull out on the top.
(3) Remove welded part of EEV by welding.(
EEV
-
mark, Pic. )
8. To remove the heat exchanger assembly
(1) Remove the drain pan.(See No.6)
(2) Remove 6 heat exchanger assy fixing
10. To remove the temperature sensors
(example"Thi-R3")
(1) Remove the lid of control box.(See No.1)
(2) Disconnect the Tho-R3 connector(CNNx)
on PCB in control box.
(3) Remove the drain pan.(See No.3)
(4) Pull out the temperature sensor"Thi-R1"
from the sensor holder.
179
-
'20 • PAC-SM-351
PFA012D631
Support
Plate
screws and remove it.( mark)
mark)
General view
2