Mitsubishi FDT100VNXWVH Service Manual page 176

6. To remove the temperature sensors (example"Thi-R1")
(1) Remove the lid of control box.(See No.1)
(2) Disconnect the temperature sensor connector(CNNx).
(3) Remove the drain pan.(See No.3)
(4) Pull out the temperature sensor
7. To remove the heat exchanger assembly
(1) Remove the drain pan.(See No.4)
(2) Remove 2 pipe lid fixing screws then remove the pipe lid.(□ mark)
(3) Remove the fan motor wiring from clip and grommet.(← mark)
(4) Remove 3 heat exchanger assembly fixing screws then remove the heat exchanger assembly.(○ mark)
8. To remove the Electronic Expansion Valve (EEV)
(1) Remove the heat exchanger assembly.(See No.7)
(2) Remove the damper sealant from EEV.
(3) Remove the coil of EEV by pull out on the top.
(4) Remove welded part of EEV by welding.(
PROCEDURE & PICTURES
"Thi-R1" from the sensor holder.
mark)
○
General view
175
- -
coil of EEV
'20 • PAC-SM-351
PJA012D792A
EEV
2