Kaba Saflok MT RFID Installation Instructions Manual page 5

MT RFID Installation Instructions
TM
Installing the lock trim
9. Connect ribbon cable, motor wire, and reader power wire to the PCB. See Fig. 4.
10. Watch for the green LED on the card reader to flash four times while you connect the battery wire to the PCB. The
green light indicates that the PCB has reset.
Important: The battery wire should be the last connection made to the PCB.
11. With the dead bolt retracted, insert the long end of the dead bolt spindle assembly through the PCB switch cam
hole and into the mortise dead bolt hub. When the mortise dead bolt is retracted, the indicator marks on the switch
cam should be at the right (3:00 position) for ADB mortises or at the bottom (6:00 position) for standard mortises
(see Fig. 4). Position dead bolt spindle assembly into cam assembly. The retaining ring should rest on the switch
cam when fully inserted (the proper positioning of the cam will allow the door to be opened when the dead bolt is
retracted and block entry when the dead bolt is thrown for privacy, except when emergency keycards are used).
Important: As illustrated in Fig. 4, be sure that the cam is in correct orientation.
12. Install the inside escutcheon with the thumb turn pointed upward.
Fig. 4
Battery
Wire
Dead Bolt
Spindle
Mortise
Motor Wire
© SAFLOK, all rights reserved.
(continued)
Battery
Route the ribbon
connector and battery
wire as shown.
Ribbon
Do not crease ribbon connector
Cable
Door Ajar
(DAJ)
Connector
(optional)
Position for the ADB mortise
lock assembly
Position for the STD mortise
lock assembly
Power
Connector
3:00 Position
ADB Mortise
OR
6:00 Position
Standard Mortise
Mortise Motor
Connector
Pg 5 of 8
INS_MTRFID_2_12