Table of Contents
Advertisement
8
4.2.2. Engine Start/Stop Procedure
Before starting the engine check the fuel and oil levels. If necessary, add fuel or oil
as described in section 8.1.1. Open the fuel valve by moving the black lever fully to
the right.
4.2.3. Using Remote Starter
1.
Set the CHOKE lever on the engine to the OPEN (Run) position (
2.
Set the key switch on the engine to the ON ( l ) position with the key vertical.
IMPORTANT: The engine will not start if the key switch is set to the anti-
clockwise (O) STOP position
3.
Set the THROTTLE switch on the control box to the ON position.
4.
Hold the ENGINE switch on the control box in the START position until the
engine starts. Release the ENGINE switch when the engine starts. The switch
is spring loaded and will return to the RUN position. In case the engine fails to
start set the CHOKE control on the engine to the CLOSED position
Return the CHOKE control to the OPEN position (
MICRON AU8115MS VEHICLE MOUNTED SPRAYER
Fig. 6 – Control Box in Cab
).
). after the engine starts.
.
(
)
Advertisement
Table of Contents
