To Start Spraying; To Stop Spraying - At The End Of Each Spray Pass; To Stop Spraying - At The End Of The Spraying Operation - Micron Electrafan 240 Instruction Manual

TO START SPRAYING

Carrying the ELECTRAFAN 110/240 in the resting position, move to the planned
starting point of the spray operation. With the sprayer still in the resting position,
switch on the motor to check the smooth running of both the atomiser disc and fan.
Never touch the atomiser disc when spinning. Then turn over the sprayer into the
spraying position, pointing it at the target and start walking immediately.
Always hold the ELECTRAFAN 110/240 slightly to the rear so that the operator
walks away from the spray. Always move the machine smoothly to ensure a steady
airstream to carry the spray droplets to the target. When the bottle is empty mark the
position where spraying stopped and restart spraying from this point. Do not walk
through any part of the sprayed area.

TO STOP SPRAYING - AT THE END OF EACH SPRAY PASS

At the end of each spray pass turn the sprayer over into the resting position (with the
bottle underneath the atomiser disc) to stop the liquid flow, then switch off the
sprayer. Move to the start of the next spray pass and start spraying again.
TO STOP SPRAYING - AT THE END OF THE SPRAY OPERATION
When spraying is finished if using water based mixtures spray out any remaining
spray mix. ULV formulations can be stored for future use. Make sure that all the
spray liquid is ejected from the atomiser disc when the bottle is empty by keeping the
motor running for a few seconds. Then switch the sprayer off.
11
Resting position
Spraying position