Table of Contents
Advertisement
3.3. Electrical Installation and Test
1.
Route the flexible conduit from the sprayer over or under the bed of the vehicle
and into the vehicle cab. Ensure that the conduit is clear of sharp edges or hot
parts (eg the engine exhaust under the bed of the vehicle) and is not vulnerable
to damage from objects placed in the rear of the vehicle.
9.
Route the cable for the control box (with the 7-pin connector) to a suitable
position in the vehicle cab.
10. Connect the control box to the cable and tighten the retaining ring on the
connector.
11. Route the battery cable to the battery in the engine compartment of the vehicle.
12. Connect the battery leads to the vehicle battery with the red wire to the positive
(+) terminal and the black wire to the negative (-) terminal.
13. Ensure that the THROTTLE switch on the control box is set to IDLE and the
PUMP switch is set to OFF.
14. Plug the connector on the battery cable into the receptacle on the battery
leads.
15. Secure the cable in the engine compartment with the cable ties provided.
Ensure that the cable is well clear of sharp edges and all moving or hot parts.
16. Put a small quantity (about 5 litres) of diesel or kerosene in the sprayer tank,
operate the valves to select the main tank, fully open the flow control valve and
place a bucket under the atomiser.
17. Set the PUMP switch on the control box to ON. Check that the pump operates
and that liquid flows from the atomiser. Set the PUMP switch to OFF.
18. Move the THROTTLE switch on the control box between the IDLE and ON
positions and check that the throttle linkage at the top of the engine above the
air filter moves between its extreme minimum and maximum positions.
19. Test the starting and stopping of the engine as described in section 4.2 below.
IMPORTANT: the engine is shipped without oil. OIL MUST BE ADDED before
starting the engine
4. CONTROLS
This section describes the main features and controls of the sprayer and gives a
brief explanation of their functions. Further details will be found elsewhere in this
manual.
MICRON AU8115MS VEHICLE MOUNTED SPRAYER
5
Advertisement
Table of Contents
