Related Manuals for Micron ELECTRAFAN 12
Summary of Contents for Micron ELECTRAFAN 12
- Page 1 Instruction manual Bromyard Industrial Estate, Bromyard, Herefordshire, HR7 4HS, UK Tel: + 44 (0) 1885 482397 Fax: + 44 (0) 1885 483043 E-mail: enquiries@micron.co.uk URL: http://www.micron.co.uk...
-
Page 3: Table Of Contents
The sprayer is designed for intermittent use. The sprayer with a full spray bottle weighs 3.25 kg, and the Micron battery weighs 6.6 kg. An electric motor spins the atomiser disc to produce uniformly small droplets which are carried to the target by the airstream generated by the fan. -
Page 4: Safety
Micron offer an optional 12 volt DC rechargeable battery and special safety re- charger. It is a sealed lead acid 17Ah (amp hour) battery fitted into a nylon case with a shoulder strap. An in-line 10 amp anti-surge fuse is fitted (see ‘THE BATTERY’). -
Page 5: Operator Protection
OPERATOR PROTECTION Always wear the protective clothing items listed on the product label for mixing and filling. The minimum protective clothing required for spraying with the ELEC- TRAFAN 12 is: face shield respirator rubber gloves and boots long sleeved shirt long trousers Note: Acoustic information: the sound pressure level at the operator’s ear is 84 dB... -
Page 6: Preparing For Spraying
The sprayer must only be used at the rated voltage. The machine must be switched off in the event of power interruption. N.B. Before spraying for the first time with the ELECTRAFAN 12, sprayer opera- tion must be checked using only water (see ‘BEFORE SPRAYING’). -
Page 7: Mixing, Filling And Calibration
MIXING, FILLING AND CALIBRATION Mixing and filling is generally the most hazardous process in the spraying operation. Always follow the label instructions. Always use a funnel when filling the bottle. Only mix enough spray for the area to be treated if using water-based mixtures to avoid the need for disposal of unused spray mix. - Page 8 2 litres of insecticide product made up to 100 litres of water per hectare with a conventional sprayer, use 2 litres of product made up to 20 litres for application with the ELECTRAFAN 12, i.e. a spray mix concentration of 10%.
- Page 9 ELECTRAFAN 12 should be moved gently up and down along the height of the crop (with the machine held to the side and slightly behind the operator’s direction of travel).
- Page 10 To check the flow rate wear the appropriate protective clothing. Choose and fit the feed nozzle that is likely to be required (see ‘TO CLEAN FEED NOZZLE’ for fitting instructions). Fill the bottle with the spray mix, attach to the sprayer (avoiding spill- age) and then turn the sprayer over above a suitable container (N.B.
-
Page 11: Before Spraying
ELECTRAFAN 12 so that it is spraying to the side and slightly behind the operator’s direction of travel. keep the spray head well away from the body to avoid the risk of direct contami- nation by the spray. -
Page 12: To Start Spraying
Then turn over the sprayer into the spraying position, pointing it at the target and start walking immediately. Always hold the ELECTRAFAN 12 slightly to the rear so that the operator walks away from the spray. Always move the machine smoothly to ensure a steady air- stream to carry the spray droplets to the target. -
Page 13: After Spraying
AFTER SPRAYING Dispose of any surplus spray mix according to the product label. Store prod- ucts safely, locked up and out of the reach of children. It is essential to clean the sprayer and bottle thoroughly after use. If using wa- ter-based mixtures a water and detergent mix should be put in the bottle, swilled around, and then sprayed out onto the treated area. -
Page 14: Diagram
ELECTRAFAN 12 PARTS DIAGRAM... -
Page 15: Parts List
ELECTRAFAN 12 PARTS LIST Item Description Part No. Qty. Item Description Part No. Qty. Label plate T/4103 Screw, D/E 2.BA x 1 -5/8” T/5128 Motor housing with handles T/A4104 Screw, D/E 2.BA x 2 -5/8” T/5129 Hand grip T/4109 Nut, 1/4” BF, nyloc... -
Page 16: Troubleshooting
Some friction from motor brushes is normal but if it is difficult to turn by hand contact your supplier or Service Department at Micron. 6. Faulty switch, internal wiring or Contact your supplier or Service Department at Micron. motor Motor runs slowly 1. Battery run down Test battery with a voltmeter or a suitably wired 12 volt bulb. -
Page 17: Storage
STORAGE Before storing the ELECTRAFAN 12 for long periods clean the fan guard with a small brush to remove any deposits and wipe the metal components with an oily rag to help combat corrosion. Store the sprayer in a clean dry place away from direct sunlight. The battery should be recharged and stored in a cool dry place. -
Page 18: To Service Motor And Switch
When charging the battery using the recharger supplied, connect the recharger leads to the battery terminals (after unplugging the ELECTRAFAN 12 from the battery) and then switch on at the mains. If the ELECTRAFAN 12 is used with other 12V D.C. batteries or rechargers consult the manufacturer for recharging information. - Page 19 DECLARATION OF CONFORMITY Name of manufacturer or supplier: Micron Sprayers Ltd. Full postal address: Bromyard Industrial Estate, BROMYARD, Herefordshire Country of origin: England Post code: HR7 4HS Description of Product: Battery powered, hand-held agricultural spraying machine. Name and model number of machine:...
- Page 20 NOTES...
- Page 21 NOTES...
- Page 22 NOTES...