To Stop Spraying; After Spraying - Micron Handy Instruction Manual

TO STOP SPRAYING

If there is any spray liquid left in the spray bottle,
keep the motor running and slowly tilt the sprayer
so that the head is above the level of the bottle and
when no more spray liquid is emitted from the at-
omiser disc, switch off the sprayer. Do not raise the
spray head above waist level with the disc still spin-
ning as spray may continue to be emitted.

AFTER SPRAYING

1. Dispose of any surplus spray mix according to
the product approval.
locked up and out of the reach of children.
2. It is essential to clean the sprayer and bottle
thoroughly using water and detergent after use.
Never immerse the spray head in water or under
a tap, since this will destroy the electric motor.
A water and detergent mix should be put in the
bottle, rinsed around, and then sprayed out onto
the treated area or an area of waste ground. The
sprayer and bottle should be wiped down exter-
nally using a cloth.
3. Periodically remove the atomiser disc with a pair of pliers and clean using a soft
brush. When refitting the atomiser disc ensure that the two small lugs on the in-
side of the disc hole align with the slot in the white shaft which attaches to the
motor.
Store products safely,
11
"Head Up" Position