Table of Contents
Advertisement
4
3. INSTALLATION
3.1.
Installation on Vehicle
The AU8115MS Sprayer can be installed on any vehicle with an open bed and an
enclosed cab to protect the driver from the spray.
positioned as far to the rear of the vehicle as possible so that when the support
frame is raised the atomiser projects behind the rear of the vehicle.
positioning the sprayer in the vehicle, ensure that there is easy access to engine
controls, starter cord, control valves, filter etc.
The frame of the sprayer should be rigidly
secured to the vehicle using the nuts, bolts,
washers and foot plates provided.
should be fitted in four holes drilled in the bed of
the vehicle in appropriate positions, taking care
to avoid the vehicle fuel tank or other vulnerable
items. Alternatively, for a temporary installation
the sprayer can be tied down with ropes secured
around the frame
3.2. Assembly of Sprayer
The AU8115MS sprayer is shipped partially dismantled and must be assembled prior
to use. The procedure for setting up a new sprayer is as follows:
1.
Position the lower ends of the sprayhead support frame between the lugs at
the rear of the sprayer frame and secure in position with the pins and R-clips
provided.
2.
Position the lower ends of the A-frame between the lugs at the rear of the
sprayer frame and secure in position with the pins and R-clips provided.
3.
Raise the support frame so that it protrudes over the rear of the sprayer.
4.
Secure the support frame by lifting the A-frame and locking in place through the
securing lug with the pin and R-clip provided.
5.
Position the spray head in the support ring. Place a red fibre friction disc
between each mounting boss and the inside of the support ring. Fix the spray
head in position with securing bolts and washers as supplied.
6.
Secure the air duct hose to the fan outlet using the hose clip provided.
7.
Connect the lower end of the feed hose to the atomiser to the outlet of the
needle valve mounted on the top of the blower casing.
8.
Fill the engine crankcase with oil as described in section 8.1.1.
MICRON AU8115MS VEHICLE MOUNTED SPRAYER
The sprayer should be
The bolts
Fig. 2 – Attachment to Vehicle
When
Advertisement
Table of Contents
