Operation; Brushing Teeth - Nevadent NSZB 3.7 B2 Operating Instructions Manual

Operation

This toothbrush has 3 different power levels:
–
"Clean": normal speed, orange "Clean" LED
For cleaning the teeth.
–
"Soft": slow speed, green "Soft" LED
For cleaning the teeth of people with sensitive gums.
–
"Pulse": slow speed with short breaks, yellow "Pulse" LED
For massaging the gums.
■ Press the on/off switch
LED lights up.
■ Press once more to switch to "Soft" mode. The "Soft" LED
■ Press it a third time to switch to "Pulse" mode. The "Pulse" LED
■ To switch the toothbrush off, press the on/off switch

Brushing Teeth

WARNING!
The unfamiliar stimulation may cause light gum bleeding at first. This is normal.
If this continues for more than two weeks, you should consult your dentist.
1) Place the brush head
2) Moisten the brush under flowing water.
3) Put a little toothpaste onto the wet brush.
NOTE
To avoid being sprayed, do not switch on the appliance until it is in your
mouth.
4) Use the on/off switch
NOTE
This toothbrush has a 30-second interval timer, so that all four jaw quadrants
can be cleaned evenly.
5) Divide your mouth into four parts (quadrants): upper left, upper right,
lower left and lower right.
6) Start in one quadrant:
Start with the brush head
downwards from the gums to the crown of the tooth.
Continue in this manner on both the inside and the outside of the tooth.
Start again at the gums for each individual tooth.
Do not forget to brush the back of the rear molars.
To clean the chewing surfaces, guide the brush over them with a little
pressure.
NSZB 3.7 B2
once to activate the "Clean" mode. The "Clean"
on the handset.
to select the desired operating mode.
on your gums, and move the brush upwards/
lights up.
lights up.
once more.
GB │ IE │ 15 ■