Nevadent NBZ 45 A1, 373276 2104 - Electric Toothbrush Operating Instructions

Introduction

The operating instructions are part of this product. They contain important information on safety, usage and disposal. Before using the product, familiarise yourself with all handling and safety guidelines. Use the product only as described and for the range of applications specified. Please also pass these operating instructions on to any future owner (s).

Intended use

This appliance is intended exclusively for personal dental care.
This appliance is intended solely for use in private homes. The appliance is not intended for use in commercial, industrial or medical environments. It is not suitable for animal care.

Package contents

• Electric toothbrush
• 4 brush heads
• 1 protective cap
• 2 batteries (Mignon/AA/LR6)
• Operating instructions

Technical data

Voltage supply	2 x 1.5 V (direct current)
Battery type	Mignon/AA/LR6
Protection type	IPX4 (splashproof)
Protection class	III / (protection through extra low voltage )

Appliance description

1. Brush head
2. On/Off button
3. Hand element
4. Battery compartment cover
5. Protective cap

Safety guidelines

• To avoid damage, do not allow liquids to penetrate the appliance and do not submerge it in water.
• Ensure that no foreign objects penetrate the appliance.
• In the event of malfunctions or obvious damage, please contact our Customer Service department.
• Cleaning and user maintenance should not be performed by children unless they are under supervision.
• Toothbrushes may be used by children and by persons with reduced physical, sensory or mental capabilities or lack of experience and/or knowledge if they are supervised or have been told how to use the appliance safely and are aware of the potential risks.
• Children must not use the appliance as a plaything.
• The appliance must not come into contact with hot surfaces. The appliance could be irreparably damaged!
• Do not open the appliance (except the battery compartment) yourself. Risk of injury if appliance is not properly assembled!

Information on using batteries

Please observe the following when handling batteries:

• Do not throw batteries into a fire. Do not recharge batteries. There is a risk of explosion and injury!
• Never open batteries and never solder or weld batteries. There is a risk of explosion and injury!
• Check the condition of the batteries at regular intervals. Leaking batteries can cause damage to the appliance.
• If you do not intend to use the appliance for an extended period, remove the batteries.
• If the batteries have leaked, use protective gloves. Clean the battery compartment and the battery contacts with a dry cloth.
• Keep batteries out of the reach of children. Children might put batteries into their mouth and swallow them. If a battery is swallowed, seek medical assistance immediately.
• Batteries must be inserted with the correct polarity.
• Always use the stated battery type.
• Do not use different types of batteries together or mix new batteries with used batteries.
• Do not short-circuit the connection terminals.
• Remove depleted batteries from the appliance and dispose of them safely.

Operation

• Remove the battery compartment cover from the hand element with a slight tilting movement and insert the batteries according to the polarity diagram in the battery compartment. Close the cover of the battery compartment again.
• Fit a brush head onto the hand element .
• Moisten the brush under flowing water.
• Add a little toothpaste onto the moist brush and guide the brush into your mouth.
• Switch on the toothbrush by pressing the On/Off button and brush your teeth on all sides. Divide your mouth into four parts (jaw quadrants): upper right, upper left, lower right and lower left (see fig. A). Start with any quadrant.
  
• Every 30 seconds, the toothbrush stops briefly twice to signal that you should start cleaning the next quadrant.
• After two minutes, the toothbrush pauses briefly 4 times. This lets you know that you have cleaned all four quadrants and complied with the dental recommendation of two minutes cleaning. Switch off the toothbrush and rinse the brush head thoroughly under running water.
• To protect the brush head , you can attach the protective cap .

Cleaning and care

• To clean the drive shaft and the hand element , allow a little water to flow over them. To do this, hold the hand element so that the drive shaft is pointing downwards. Make sure that no water gets into the battery compartment.
• After use, clean the brush head thoroughly under running water.
• You should fit a new brush head after about 3 months, or when the bristles start to bend outwards.