Miele EVS 6114 Operating And Installation Instructions page 6

Built-in vacuum drawer
Table of Contents

Advertisement

Warnings and safety instructions
Technical safety
Installation, maintenance and repair work should only be
performed by a Miele authorized service technician. Installation,
maintenance and repair work by unqualified persons can cause
considerable danger to users.
Damage to the drawer can compromise your safety. Check the
appliance for visible signs of damage. Do not use the appliance if it
is damaged.
Pay attention to any damage or cracks to the glass lid or chamber
seal. Damage to the glass lid can cause implosion. Never operate
the drawer if the glass lid and/or the chamber seal is damaged.
The drawer has an integrated vacuum pump which contains oil. To
prevent oil from leaking out, the drawer must be transported and
stored in a horizontal position only. Do not tilt the drawer and do not
stand it up on its side.
The manufacturer's warranty will be invalidated if oil has leaked out
of the pump because it has not been transported or stored correctly.
Reliable and safe operation of the drawer can only be assured if it
has been connected to the domestic electrical supply.
The electrical safety of the drawer can only be guaranteed when
properly installed and grounded by a qualified technician. To
guarantee the electrical safety of this appliance, continuity must exist
between the appliance and an effective grounding system. It is most
important that this basic safety requirement is fulfilled. If in doubt,
the electrical installation should be checked by a qualified
electrician.
The connection data (voltage and frequency) on the data plate of
the drawer must match the domestic electricity supply in order to
avoid the risk of damage to the drawer. Compare this data before
connecting the appliance. Consult a qualified electrician if in any
doubt.
6

Advertisement

Table of Contents
loading

Table of Contents