Table of Contents
Advertisement
B.1
Safety Precautions
The optical characteristics are measured under stable conditions at 25°C (room tem-
perature).
1.
Since front polarizer is easily damaged, pay attention not to scratch it.
2.
Be sure to turn off power supply when inserting or disconnecting from input con-
nector.
3.
Wipe off water drops immediately. Lengthy contact with water may cause discol-
oration or spots.
4.
When the panel surface is soiled, wipe it with absorbent cotton or other soft
cloth.
5.
Since the panel is made of glass, it may break or crack if dropped or bumped on
hard surface.
6.
Since a CMOS LSI is used in this module, be aware of static electricity and
insure equipment and personnel are properly grounded when handling.
7.
Do not open or modify the Module Assembly.
8.
Do not press the reflector sheet at the back of the module in any direction.
9.
If a module has to be put back into the packing container slot after having been
taken out, please press the far ends of the LED light bar reflector edge softly.
Otherwise the TFT Module may be damaged.
10.
During insertion or removal of the Signal Interface Connector, be sure not to
rotate or tilt the Interface Connector of the TFT Module.
11.
After installation of the TFT Module into an enclosure, do not twist nor bend the
TFT Module even momentarily. When designing the enclosure, care should be
taken not to bend/twist the TFT Module from outside. Otherwise the module
may be damaged.
12.
Small amounts of inflammable materials are used in the LCD module. The LCD
module should be supplied by power that complies to requirements for a Limited
Power Source (IEC60950 or UL1950) or an exemption should be applied for.
IDK-2115 User Manual
34
Advertisement
Table of Contents
