Fagor Dro NV-300T Installation Manual page 36

or...
- Preset the axis with value 22.601 by pressing:
validate it.
In case of a mistake, press
When pressing
- Move the axis towards the first position until the DRO reads: 0.000.
This last method turns out to be more practical as after selecting the
destination coordinate one only has to remember to move the axis until
the DRO reads zero.
- Once this turning operation has concluded, one can go to the next position,
after having preset the next coordinate (24.337), by moving the axis until
the display reads 0.000.
- And so on until all the turning operations are concluded.
Note: By pressing
the axis real position with respect to part zero "O"
Page: 12 - Operation Manual
to cancel it and leave it as it was.
C
, the previously preset value is displayed.
until the "ABS" LED lights up, the DRO will show
+
-
NV-300T/301T Man: 9910 Soft: 2.xx
22.601 to
ENTER